Heat Pumps Wellington – How To Install A Heat Pump?

It’s always tricky to install heat pumps Wellington. People often don’t know how to make it happen. There are 5 main steps involved in a heat pump installation. Don’t you know those steps?

Here is a step-wise guide to explain the heat pump installation process in detail:

Step 1: Install The Condenser

First of all, you need to install the condenser. A condenser should be installed outside the house, so the heat and air can be transferred throughout your place. The basic purpose of a condenser is to move both heat and air to the desired room.

Step 2: Add Air Handle Mount

Now is the time to add an air handler. Here’s an expert opinion; you need to find a suitable spot to add your air handler. Because it will release both cool and warm air into the room.

On average, you need to add an air handler within 30 feet of your already installed condenser. Once it is done, all you have to do is connect both of them together. Make sure the air handler is nowhere near your television.

Step 3: Mount Air Handler

Once the air handler is added, it’s time to mount it. Mounting is necessary to make sure all the lines are connected safely. It’s always good to connect refrigerant lines, cold wires, and condensate hose with the help of a tie or a tape.

All three of them should be covered to make sure none of them rip when you try to sneak them through your wall.

Step 4: Connect The Air Handler To The Condenser

Now is the time to connect the air handler to the condenser. Once you sneak all the wires through the wall, make sure you connect outdoor unit power to a breaker cable.

At last, you need to connect the refrigerant lines to the condenser. In order to get extra protection, make sure you use flare nuts for heat pump installation Wellington.

Step 5: Cover The Lines And Make The Final Connection

All the wires should be covered properly to avoid any possible damage. You can use plastic covering to cover your fire if they are more than a few inches outside.

In the end, connect a gauge manifold and vacuum pump to your refrigerant lines.

Conclusion

Heat pumps Wellington are not easy to install. However, this step-wise guide will make the process a lot easier for you.